Water Fittings

Repair clamps

BRIEF DESCRIPTION

Repair clamps for failures on pipes with flat outer surface, either plastic, stone or metal. They consist of fixing elements of cast iron with clamping screws and bolts of galvanised steel, and a stainless steel band with a NBR rubber surface on the inside for winding the pipe where the failure is located. Diameters range from DN 16 up to DN 750 mm. Clamps  are used for temporary repairs on pipes that are used for water or gas distribution with or without pressure. Upon request, it is possible to take into consideration the production of models for customised diameters.

MAIN FEATURES

Application flexibility
Easy and quick to use
Reliability
Wide range of sizes and performances

Electrofusion fittings Sabfuse

BRIEF DESCRIPTION

PE100 Electrofusion fittings for connecting elements of polyethylene pipes (coils, bars, folders with flanges, special pieces) with pressurized and non-pressurized pipelines for the distribution of gas and water (for human consumption too). The electrofusion fittings have an inner metallic thread that, thanks to the passage of electricity, generates the heat requested for the fusion of the polyethylene in the inner surface of the fitting and the outer surface of the pipe, thus allowing the welding between the two elements. This operation takes place through welding machines, powered by specific generators connected to the fitting through cables inside the specific pins. There are also the “fusion witnesses” which are useful for the visual inspection of the properly fusion. The installation instructions can be read automatically by the device trough the barcode reported on every single fitting. Wide range of shapes (sleeves, bends, derivations, TEE pieces etc..) and diameters to work at nominal pressures of 6, 10, 16 and 25 bars.

MAIN FEATURES

Complete system
High tightness reliability
Fusion on the outer surface of the pipe (the inner welding seam is not created)
Suitable for pressurized and non-pressurized systems, up to 25 bar

PE STEEL transition fittings

BRIEF DESCRIPTION

PE-STEEL transition fittings, consisting of a SDR11 polyethylene sleeve (PE100) in accordance with UNI EN 1555 (for gas) or UNI EN 12201 (for water) standards which is suitable for the connection with PE 100 pipes (S5 for gas – PN16 for water) + a steel sleeve made of pipes in accordance with UNI 8863 standard, galvanised on the inside and with male threaded end or suitable for the welding connection. These fittings are used for underground fluids distribution systems (usually PE) which become above ground systems. These last ones are preferred to be made of steel for the advanced mechanical characteristics of impact resistance (accidents or acts of vandalism). The range of shapes includes: straight or elbow (45°- 90°). Transition fittings of PE-BRASS are available too.

MAIN FEATURES

Safety
Wide range of professional choices
Lightness
Practicality

Segmented fittings for solid wall HDPE pipes

BRIEF DESCRIPTION

Fittings and special pieces consisting of sectors of high density polyethylene pipes with solid and smooth wall. They are available in black colour (with or without external coextruded coloured bands), in 2 layers (black on the inside and coloured on the outside) or coloured on the inside. The diameters range goes from 20 up to 1200 mm and of every kind of SDR.

MAIN FEATURES

Good drainage capacity
Pre-installed external filter sock
Cost-effective installation
Lightweight
Wide range of diameters
Inert to stray currents
High chemical resistance (ISO /TR 10358)
High abrasion resistance
High shock absorption resistance
Recyclable